Wiring 555 IC as a Square Wave Oscillator for Two LED Flasher Application


Wiring 555 IC as a Square Wave Oscillator for Two LED Flasher Application: circuit  of two led flasher application kit using lm or ne555 ic thumbjpg

After previously article discuss about 555 IC, the following article will provide you with an application kit – a two LED Wiring 555 IC as a Square Wave Oscillator for Two LED Flasher Application: circuit  of two led flasher application kit using lm or ne555 ic thumbjpg
flasher which uses 555 IC Timer to be wired as a Square Wave Oscillator (astable operation mode). This application kit has a double ended output connection in which the LEDs will start to flash simultaneously ON and OFF when connected to a battery or 5V to 15V power supply.

The circuit diagram shown above perform how to assembly of the two LED flasher application kit. And these are the following component to be applied: 2 pcs 820R grey red brown for R3 R4, 2 pcs 1K brown black red
for R1 R2, 1 pc Koa trimpot 100K 104, 1 pc ceramic capacitor 10n 103
(C1), 1 pc electrolytic capacitor 10uF (C2), 2 pcs 5mm re LED for L1 L2,
an LM/NE555 IC, a 8 pin IC socket, and a 3138 PCB.

You
are also provided with informations such an animation of what happens
in this two LED flasher, or entering values for R1, R2, C and what flash
rate would these component give. Follow complete read of Wiring 555 IC as a Square Wave Oscillator for Two LED Flasher Application in this 555 Application Datasheet (source: quasarelectronics.com).


Sorry, comments are closed!