Tone Control


Two-Band Bxandall Active Tone Control

Using active circuit for tone control means that we can provide cut and boost, maintaining overall amplifying factor of original system (before adding the tone control). Very simple circuit can be built using Baxandall configuration, which uses only capacitors, resistors, and one transistor. The firs potentiometer give treble cut and boost. Note that the potentiometer […]



Transistor stereo bass booster

This is a bass booster that use transistors as base. It is designed to increase a low frequency of audio on cheaper than ICs or normally circuit. since use each channel only 2 transistors together with resistor and capacitors approximately ten parts only. In circuit will be have a potentiometer trimmer 10-50K act as adjusted […]




Simple Passive tone control circuit

The Passive tone control circuit be the circuit fines the bass that has no the expansion but will give kind equipment R and C. It perform filter frequency then the circuit that build easy and must not use power supply. By can concede the porch with part power amplifier of output immediately. When feed input […]


5 Channels Graphic Equalizer by LA3600

This circuit 5 Channels 2 Octave Graphic Equaliser,easy to make equalizer, because using IC LA3600 (easy to use) For you who take an interest sound of music side may nobody strange Graphic Equalizer circuit , but , in you who are a novice , something will build this some group circuit gets into trouble moderately […]


Pre-Amp + Tone Control with TDA1524A circuit diagram

This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram: Component: Resistors: R1, R2__________________ 220R R3, R4__________________ 4K7 R5______________________ 2K2 R6______________________ 1K Capacitors: C1, 2, 7, 8, 17_________ 10 […]


Stereo Tone Control with LM1036 circuit diagram

This is a stereo audio tone control circuit which build based on ICĀ  LM1036. This circuit will controll bass/treble level tone, volume and balance between right channel and left channel (input 1 and 2 ). You may use this circuit for stereo applications such as car radio, TV and audio systems, mp3 player, dvd player, […]


Hi-Fi Tone Control circuit diagram

This is a cheap high fidelity (hi-fi) tone control circuit. The schematic is one channel (mono) tone control, build the similar circuit will make it become stereo. Use good component (such as metalfilm resistors, MKM capacitors, tantalum capacitors, good cable quality) and stabilized power supply for better sound quality output.The quality of component, cabling and […]