The present tester is intended primarily for testing the 24 V electrical circuits found on most pleasure craft. However, if the resistors are given different values, the circuit may, of course, be used for other voltage ranges. For 12 V, the value of the resistors should be 1.2 k?, and for 48 V, 4.7 k?. […]
When testing circuits with a logic probe, it is sometimes difficult to watch the LEDS on the probe to determine the logic state. With this probe the logic states are audible. This probe is designed for TTL circuits only but could be modified for CMOS. The way it works is as follows. The 5 volt […]
1999 Saturn SW2 Fuse Box Diagram 1999 Saturn SW2 Fuse Box Map Fuse Panel Layout Diagram Parts: battery, ground, body harn, chime module, ignition switch, radio, wiper/washer, power window, sunroof, turn signal, chime, door lock, air bag, cruise, probe, fuel pump.
2001 Saturn SW2 Fuse Box Diagram 2001 Saturn SW2 Fuse Box Map Fuse Panel Layout Diagram Parts: chime module, sunroof, turn signal, chime, door lock, air bag, ignition switch, radio, wiper/washer, power window, cruise, probe, fuel pump, battery, ground, body horn.
This logic probe can be selected to operate on TTL or CMOS logic levels, depending on switch S1. A string of resistors associated with switch S1 sets the threshold levels for a window comparator comprising IC1a and IC1b. Depending on whether the level applied to the probe is high or low, the window comparator turns […]
This item describes a simple probe that allows in-situ AA and AAA battery voltage and current drain measurements without removing the cells from the holder. In use, the probe is simply pushed between the positive end of one cell and either the negative end of the adjacent cell or the battery holder terminal. The probe […]