Super dancing AC lights 4500 watt using opto isolator


I am extremely proud to present to you this circuit. We dare to challenge that. When you have contact with the circuit. You may have forgotten to do another circuits.
In addition to the ability to work resolutely. The circuits is designed. With safety as a priority. So we use optocoupler isolator to isolate the AC line power circuit and the control system circuit is strictly prohibited.
In addition will is protection from electric shock to the user. One thing is important. The protection of the AC line power is not doing any harm to your machine.
And sitting circuit to an input circuit has a value up to 50K OHM. So make sure that your audio device of any size Both a high power or a low watt amplifier will not be certainly loaded until failure.
In Figure 1 is shown block diagram of the super dancing lights of 4,500 watt will see that the input signal is entered through the filter circuit. Which the filter to each series will qualify with frequency as follows.
The low pass filter will allows the frequency under 200HZ only.
The band pass filter will allows the frequencies only over 2000HZ up.
The signal from the filter circuit will pass through a schmitt trigger circuit to controls a light flashing as on-off, is rhythmic by the sound signal absolutely different from other circuits that you use to see ago.
The output signal from the schmitt trigger circuit send to the OPTO ISOLATOR circuit to drive the driver circuit and output.

Super dancing ac lights 4500 watt using opto isolator

Note more related projects: Cheap Home disco lights • AC lights dimmer • Very cheap ac light dimmerAutomatic light dimmer • Super AC dimmer • 1200 Watt AC Dimmer

How this circuit works.
The input signal of the speaker will be entered pass through a input resistor R1 come to a master control volume, that act as control a level of a input signal that will enter to the filter circuit to has good enough level. Do not strong too much, or a little.
The output signal from the master volume will apply from the potentiometer , that act adjust a level signal each channel to the filter circuit each set to has level of signal Appropriately as needed.

The low range frequency signal will be fed through R1, C1 to the transistor Q1(BC557) to pin 12 of IC1-(MN5693BN) , which act as the schmitt trigger circuit has the output pass the R16 to IC2-(TLQ-074) the opto isolator, that has output to drive the driver Q5(BC547) go to a triac Q8 makes the lamps lit up as the strength of the signal at low frequencies.
For high frequency entering through C3, C4 to Q3. and the schmitt trigger circuit pin 5 to the IC2 to drive the lamp at the Q7 circuit , In the same manner. Frequency range can be entered through the band pass filter circuit comprising R14, C5, C2 to base of Q2(BC557) and the schmitt trigger circuit at pin 8 to drive the load driver Q9(BTA10-400V) as with other circuits.
As see that the power supply circuit is divided into two parts, one will be supplied to the input control circuit.
And another pass to the driver circuit Q4(BC547)-Q6(BC547) makes the control circuit isolated from the AC line power-220V is strictly prohibited. It is to ensure 100% safety.

How to assemble circuit.
All equipment can be assembled onto the PCB, as shown in Figure 2.

Pcb super dancing ac lights 4500 watt using opto isolator

All devices on assembly PCB correctly. Check the soldering tightly successfully. Then, check this PCB, that there is short circuit or not, In particular, the point at which the AC-Line power and The control circuit may cause life threatening.
When assembly experiment was to apply the power AC to the circuit. All bulbs lamps will be be extinguished completely. Try connecting the input signal from the amplifier speaker of any side of half time. Be careful not Provide short circuit the input wire is determined by the output of power amplifier may be damaged.
Try refining. potentiometer on the lamp lit by the strength of the input signal is fed into the desired range.


Sorry, comments are closed!