Simple Lamp Dimmer/ Fan Regulator

A Lamp Dimmer/Fan Regulator Circuit

We have modified this circuit: – Take a lookModified Lamp Dimmer

Description .

This is the circuit diagram of the simplest lamp dimmer or fan regulator.The circuit is based on the principle of power control using a Triac.The circuit works by varying the firing angle of the Triac . Resistors R1 ,R2 and capacitor C2 are associated with this. The firing angle can be varied by varying the value of any of these components. Here R1 is selected as the variable element . By varying the value of R1 the firing angle of Triac changes (in simple words, how much time should Triac conduct) changes. This directly varies the load power, since load is driven by Triac. The firing pulses are given to the gate of Triac T1 using Diac D1.


Assemble the circuit on a good quality PCB or common board.The load whether lamp ,fan or any thing ,should be less than 200 Watts. To connect higher loads replace the Triac BT 136 with a higher Watt capacity Triac . All parts of the circuit are active with potential shock hazard.So be careful.

I advice to test the circuit with a low voltage supply (say 12V or 24V AC) and a small load (a same volt bulb) ,before connecting the circuit to mains.

Parts List

R1 1o K 1 Watt Resistor

R2 1o0 K Potentiometer (Variable Resistance)

C1 0.1 uF (500V or above ) Polyester Capacitor

T1 BT 136 Triac

D1 DB2 Diac

Fan Regulator Circuit Diagram

Lamp dimmer and fan regulator

BT 136Triac Necessary Data.

BT136 specification

BT 136 Specifications

Sorry, comments are closed!