Negative Auxiliary Voltage


Some circuits need a
negative supply voltage that only has to supply a small current.
Providing a separate transformer winding for this (possibly even with a
rectifier and filter capacitor) would be a rather extravagant solution.
It can also be done using a few gates and several passive components.
The combination of gate IC1a and the other three gates (wired in
parallel) forms a square-wave generator. D1 and D2 convert the ac
voltage into a dc voltage. As a CMOS IC is
used here, the load on the negative output is limited to a few
milliampères, depending on the positive supply voltage (see chart),
despite the fact that three gates are connected in parallel.

Circuit diagram:

Negative Auxiliary Voltage Circuit

Negative Auxiliary Voltage Circuit Diagram

However, as the figure shows, the negative voltage has almost the
same magnitude as the positive input voltage, but with the opposite
sign. If a clock signal in the range of 10–50 kHz is available, it can
be connected to the input of IC1a, and R1 and C1 can then be omitted.

Author: Ludwig Libertin – Copyright: Elektor Electronics


Sorry, comments are closed!