LED Flasher 2-Transistors circuit diagram


The following is LED Flasher circuit which use 2 transistors for LED switching. The circuit works similar to flip-flop operation.
2 Transistor LED Flasher

Component Parts List:

R1 = 10M ohm
R2 = 1K – 100K ohm
R3 = 470 ohm
C1 = 0.47μF – 10μF/25V
D1 = 1N914
Q1 = 2N3904
Q2 = 2N3906
Led = High Brightness Red LED

This circuit will flash a bright or high-brightness red LED (5000+ mcd). Great for fake car alarm or other awareness getting equipment. Component values aren’t significant, attempt anything else first from the junkbox.Obviously, the 470 ohm resistor (R3) determines the LED’s brightness and limits the current flow to around 20mA. R3 value of 390 ohm can also be implemented as a save value.

If you determine to go with a green or yellow led, which take extra current, you might wish to change the 470 ohm with an proper value. Flash rate is determined by R2 and C1 and it is approximately three time constants (3*R2*C1). R1 provides bias to Q1 which should be low enough not to saturate Q2 with the capacitor disconnected. When the circuit does not oscillate, R1 may be too low or R2 too high. D1 allows for higher duty cycle operation and limits the feedback at the base of Q1 to -0.7 volts. D1 might be ommited for low supply power like 6 – 9V and low duy cycle operation.

Circuit design by Tony Van Roon


Sorry, comments are closed!