Home Network for ADSL


The increased availability of fast ADSL
Internet connections has made it more attractive to install a small
RJ45 Ethernet network in the home. Not only can you exchange files
between computers, you will also have fast Internet access for
everybody! This does of course require an ADSL modem with a router. It’s not possible to use a simple USB
modem on its own. For laptops we recommend wireless Ethernet
connections. If you find the laying of cables too difficult or
inconvenient you can also add wireless capabilities to ‘ordinary’ PCs.
You should bear in mind that the range of wireless connections could
sometimes be disappointing. When a network is set up round a router you
should use a star configuration for the cabling. This means that only a
single PC is connected to each router socket.

The connecting cable may have a maximum length of 90 m and usually
terminates at a connection box. You should use a CAT5 cable with 8
conductors for this, which is suitable for speeds up to 100 Mb/s. The 8
conductors are arranged in 4 pairs, with each pair twisted along the
length of the cable. It is extremely important that the wires of each
pair are kept together and that they are kept twisted as much as
possible. At the connector ends you should therefore make sure that the
non-twisted sections of the cable are kept as short as possible, at most
a few centimetres. Should you fail to do this you may find that the
network won’t operate at the full rated speed or possibly cause
interference. The wiring itself is very simple. Connect the plugs to the
cables such that each pin connects to the corresponding pin at the
other end.

So pin 1 to 1, 2 tot 2 and so on. This also applies to all patch
leads between the connection boxes and PCs (or if you prefer, the cable
can go directly to the PC, without a connection box). It is only when
two computers are connected directly together without a router that a
crossover cable is required. The plugs are attached to the cable using a
special crimping tool. It is also possible without the tool, using just
a screwdriver, but this isn’t easy and we don’t recommend that you try
it. The wires in the cable have different colours and there are no
official standards in Europe how you use them (EN50173). However, the
colour code in the American T568B standard is often used:

  • orange/white
  • orange
  • green/white
  • blue
  • blue/white
  • green
  • brown/white
  • brown

The coloured/white wires and the solid coloured wires alternate
nicely. For Ethernet cabling you only need connections 1, 2, 3 and 6.
The central contacts on pins 4 and 5 are in the middle of the green pair
and may be used for analogue telephones. You then have to make sure
that 4 and 5 aren’t connected to the Ethernet plugs because the voltages
found on analogue telephone lines are high enough to damage an Ethernet
card and/or router. Wires 4 and 5 should then be routed to an RJ11
telephone socket. We don’t recommend it, but it is possible. It is also
possible to pass ISDN signals through the same RJ45 plugs and cabling. In this case you can’t use the same cable for both Ethernet and ISDN, since the latter uses pins 3/6 and 4/5.

If you use patch cables it helps to keep things organised by using
coloured cables. Blue for Ethernet (red for a crossover cable), yellow
for analogue telephones and green for ISDN.
Sticky labels or coloured cable markers can also be used for
identification when you can’t get hold of coloured cables. A new
standard has recently been introduced, although you probably won’t use
it in the home for a while. Since around two years ago you can also use a
GG45 connector, which is compatible with RJ45. This has 4 extra
contacts and is suitable for speeds up to 600 Mb/s (Category 7/Class F).

Author: Karel Walraven
Copyright: Elektor Electronics

Circuit search tags:


Sorry, comments are closed!