FlatLink 10-85MHz Transmitter

FlatLink 10-85MHz Transmitter


The SN75LVDS83C FlatLink transmitter contains four 7-bit parallel-load serial-out shift registers, a 7X clock synthesizer, and five Low-Voltage Differential Signaling (LVDS) line drivers in a single integrated circuit. These functions allow 28 bits of single-ended LVTTL data to be synchronously transmitted over five balanced-pair conductors for receipt by a compatible receiver, such as the SN75LVDS82 and LCD panels with integrated LVDS receiver.

When transmitting, data bits D0 through D27 are each loaded into registers upon the edge of the input clock signal (CLKIN). The rising or falling edge of the clock can be selected via the clock select (CLKSEL) pin. The frequency of CLKIN is multiplied seven times, and then used to unload the data registers in 7-bit slices and serially.

View full Description in Datasheet

Device Uses
  • LCD Display Panel Driver
  • UMPC and Netbook PC
  • Digital Picture Frame
  • LVDS Display Serdes Interfaces Directly to LCD Display Panels with Integrated LVDS
  • Package: 4.5mm × 7mm BGA
  • 1.8V up to 3.3V Tolerant Data Inputs to Connect Directly to Low-Power,
  • Low-Voltage Application and Graphic Processors
  • Transfer Rate up to 85Mpps (Mega Pixel Per Second);
  • Pixel Clock Frequency Range 10MHz to 85MHz
  • Suited for Display Resolutions Ranging From HVGA up to HD With Low EMI
  • Operates From a Single 3.3V Supply and 148mW (typical) at 75MHz
  • 28 Data Channels Plus Clock In Low-Voltage TTL to 4 Data Channels
  • Plus Clock Out Low-Voltage Differential
  • Consumes Less Than 1mW When Disabled
  • Selectable Rising or Falling Clock Edge Triggered Inputs
  • ESD: 5kV HBM
  • Support Spread Spectrum Clocking (SSC)

Sorry, comments are closed!