0-15 Volt Tracking dual Power Supply by IC 741 + MJ2955

0 15 Volt Tracking dual Power Supply by IC 741 + MJ2955

The linear dual tracking power supply, shown in the schematic, provides 0-15 volts, at 1/4 amp, maximum, using a discrete transistor regulator with op-amp feedback to control the output voltage. The supply was constructed in 1975; the negative ouput voltage tracks the positive output voltage.
With reference to the schematic, lamp, LP2, is a power-on indicator. There is no adjustable current limiter in this unit, although R1, D2, and D3 set the current limit to approximately 0.25 amps on the positive side, and R15, D9 and D10 set the current limit to slightly greater than 0.25 amps on the negative side. The voltages at the output of Q1, and Q3 are pre-regulated to 20 volts so that the op-amp supply voltages do not exceed the maximum supply ratings for these op-amps. R9, R12 and U2 cause the negative supply to track the positive output voltage. R7 is a front panel potentiometer to adjust the output voltage(s).

Read More Source:


Sorry, comments are closed!